800.967.6696 | crateandbarrel.com
1
2
Insert 2 wood dowels into left end panel as shown. Attach 2 brackets to left end panel with 1 end panel bolt per bracket.
Secure bolts, but do not over tighten, with a small Allen wrench. At this point, insert 1 end panel bolt into the exposed
hole in left end panel as shown. Repeat steps for remaining right end panel.
Fit brackets and dowels of left end panel into corresponding holes of 2 side panels. Using a small Allen wrench, secure
top of each side panel with 1 end panel bolt as shown. Using a small Allen wrench, secure bottom of each side panel
with 2 large bolts, 2 spring washers and 2 half-moon brackets.
Made in Vietnam - r05
Andersen Crib Assembly Instructions
Page 3 of 6
exposed hole
for toddler rail
assembly
Left end
panel
To Next Page
Loading...
