Crate&Barrel Andersen Crib - Step 2: Attach End Panels to Side Panels; Connect Left End Panel to Side Panels; Secure Side Panel Tops; Secure Side Panel Bottoms

800.967.6696 | crateandbarrel.com
3
4
Fit brackets and dowels of right end panel into corresponding holes of 2 side panels. Using a small Allen wrench,
secure top of each side panel with 1 small bolt as shown. Using a small Allen wrench, secure bottom of each side panel
with 2 large bolts, 2 spring washers and 2 half-moon brackets.
Determine the desired height (low, middle, high) for the crib mattress. Fit each support pin into corresponding corner as
shown. Make sure support pin is securely engaged with assembly.
Made in Vietnam - r05
Andersen Crib Assembly Instructions
Page 4 of 6
Low
Middle
High
Right end
panel