Crathco Simplicity Bubbler CS-3L

Questions and Answers

J
Justin BennettAug 12, 2025
Why is there no product agitation in my Crathco Simplicity Bubbler CS-3L Dispenser?
- R
  Raymond LopezAug 12, 2025
  Lack of product agitation in your Crathco Dispenser can be due to a worn impeller and/or axle. If these parts are worn, replace them. If the pump motor magnet needs adjustment, it is recommended to call for service.
R
Richard DavisAug 17, 2025
Why is my Crathco Simplicity Bubbler CS-3L leaking?
- D
  Daniel Brown IVAug 17, 2025
  A Crathco Dispenser may leak due to several reasons. It could be that the O-ring is nicked, there are foreign particles on the bowl valve seat, the drain tray is overflowing, the valve isn't securely in place, or the gasket isn't properly seated. Here's how to address these issues: * If the O-ring is nicked or there are foreign particles on the bowl valve seat, replace the bowl. * If the drain tray is overflowing, empty the tray. * If the valve isn't secure, push and twist it to seat it properly. * If the gasket isn't seated, push it to seat it.
J
James FuentesAug 25, 2025
What to do if Crathco Dispenser has poor refrigeration?
- T
  Tamara MccoyAug 25, 2025
  Poor refrigeration in your Crathco Dispenser can stem from several causes. The condenser filter and condenser might be dirty, or there could be no product agitation. Also, the impeller might not be spinning, the compressor might not be operating (while the fan also isn't operating), or the thermostat could be faulty or improperly set. * Clean the condenser or call for service. * For other causes, it is recommended to call for service.
D
Deborah MorrisAug 29, 2025
Why is my Crathco Dispenser machine so noisy?
- J
  Jerome RichardsAug 30, 2025
  A noisy Crathco Dispenser can be caused by several factors. The impeller might not be installed correctly in the bowl, or the bowl or pump might have been installed while the unit was in the “on” position. Also, there may be faulty pump motor bearings, a chattering impeller, a broken impeller, or a bent fan blade. Here's how to troubleshoot: * If the bowl or pump was installed while the unit was on, turn the unit off and reinstall the parts. * If the impeller is broken, replace it. * If the fan blade is bent, unplug the unit, remove the side panel, and inspect the fan blade. * For other causes, it is recommended to call for service.
K
kristyfrancisSep 4, 2025
What to do if Crathco Simplicity Bubbler CS-3L Dispenser has no refrigeration?
- S
  Sandra GarciaSep 4, 2025
  For Crathco Dispensers with no refrigeration, ensure the unit is plugged into a wall outlet and that the power switch is on. For other refrigeration issues, it is recommended to call for service.