Crathco SPM MP - User Manual

Questions and Answers

M
Megan AndrewsAug 4, 2025
What to do if Crathco SPM MP doesn't run when the main switch is ON?
- E
  Erica MendozaAug 4, 2025
  If your Crathco Dispenser doesn't run even when the main switch is in the ON position, consider these potential causes: First, ensure the front flange is correctly positioned. Next, check all electrical connections to confirm they are properly connected. If these steps don't resolve the issue, the switch itself may be broken and require replacement. Alternatively, the electronic panel or the agitator motor could be defective, necessitating their replacement.
J
Janice MartinAug 9, 2025
What to do if nothing comes out of the tap of Crathco SPM MP?
- R
  Robert PalmerAug 9, 2025
  If your Crathco Dispenser is running with liquid in the top tank, but nothing dispenses from the tap, there are a couple of things to check. First, the pipe connecting the upper tank to the lower freezing cylinder may be clogged; inspect and unclog it. Second, the mixture in the cylinder might be too dense. Determine why it's thickening, resolve that issue, and then restart the appliance with a fresh mix.
P
paulgordonAug 16, 2025
Why Crathco SPM MP does not cool properly when the compressor is running?
- R
  Rebecca BakerAug 16, 2025
  If your Crathco Dispenser isn't cooling adequately while the compressor runs, several factors could be the cause. Check if the space around the appliance allows at least 20 cm of free space for ventilation and is away from heat sources. Ensure that the appliance is in cooling mode, not wash mode. Also, verify that the fan is functioning correctly by checking its electrical connections; replace the fan if necessary. Finally, a loss of coolant could be the issue; in this case, locate and repair the leak, then recharge the system.
D
Daniel PerezAug 21, 2025
How to fix a Crathco Dispenser that doesn't cool and the compressor is not running?
- D
  Dillon BarnettAug 21, 2025
  If your Crathco Dispenser isn't cooling and the compressor isn't running, it could be due to several reasons. Start by checking the electrical components of the compressor and replace any that are not functioning. Also, inspect all electrical connections to ensure they are securely connected. If the compressor itself is defective, it will need to be replaced.
D
Daniel AguilarAug 27, 2025
How to reduce noise from Crathco Dispenser?
- J
  Jacob LopezAug 27, 2025
  Excessive noise from your Crathco Dispenser can often be traced to a couple of issues. If the beater and its components weren't installed correctly, dismantle the beater and reassemble the parts properly. Also, check if the fan blades are hitting any internal parts and adjust as necessary.