- Page 16 -
Repeat the same thing for submenu L04 which is the total operating time and perform
the service required according to the service manual.
6. Perform the service and maintenance recommended by the service manual.
7. When the service is done it is time to reset the service counter “trip-meter”. Do this
according to §2.2.3 and §2.2.4. Remember that it is only possible to reset the “trip-
meter” and not the total counter or “Odometer”.
It is also possibly to do a total service reset via submenu L20, which is explained in
detail in §2.2.5.
8. Now one may change the service interval if there is a need for another interval than pre-
set cycles* (see also the service manual). This is done in submenu L06 and submenu
L07 and is explained in detail in §2.2.2.
9. The service is now ready and the leveller can be handed over to the customer again after
filling in the logbook.
* Factory setting number of days and / or cycles
for service indication:
LEVELLER 365 days / 3000 cycles
To Next Page
Loading...