- Page 22 -
3.1.3 Selection between Summer / Winter function:
Function to “winter” mode (Shelter function enabled):
The Leveller in resting position, door closed and the shelter switched off.
1. Press push button S10 <AUTO> for 5 sec. If summer mode is active display will flash
S00.
2. Press button S8 <OPEN DOOR>, [S00] will be displayed for 2 sec. and winter mode is
selected.
Function to “summer” mode (Shelter function disabled):
The Leveller in resting position, door closed and the shelter switched off.
3. Press push button S10 <AUTO> for 5 sec. If winter mode is active display will flash
S01.
The display on the Service tool shows the state of the leveller, shelter or the door.
Press LEFT BUTTON SW1 two times, menu [S] is showed. Enter Shelter submenu by
RIGHT BUTTON SW2, S01 is showed.
To Next Page
Loading...