Cray ClusterStor L300N

Need help?

Do you have a question about the Cray ClusterStor L300N and is the answer not in the manual?

Summary

Prerequisites to Installation

Service Area Clearances

Specifies required clearances around the rack for service access.

Install Disk Drives in a 5 U84 Enclosure

Cable the External Power Connections

Prerequisites

Conditions required before cabling external power.

Reset the Circuit Breaker

Procedure to reset circuit breakers on the PDU.

Reset a Circuit Breaker on a Raritan PDU

Procedure to reset circuit breakers on a Raritan PDU.

Cable Inter-rack Local Management Network (LMN)

About this task

Explains inter-rack cabling for the Local Management Network (LMN).

Environment Connections

Cable SMU and 36-Port InfiniBand EDR LDN with Dual 24-Port LMN Switches

Connects SMU, InfiniBand LDN, and 24-port LMN switches.

Cable SMU and 36-Port InfiniBand EDR LDN with Dual 48-Port LMN Switches

Connects SMU, InfiniBand LDN, and 48-port LMN switches.

Cable SMU and 36-Port 40 GbE LDN and Dual 24-Port LMN Switches

Connects SMU, 40GbE LDN, and 24-port LMN switches.

Cable SMU and 36-Port 40 GbE LDN with Dual 48-Port LMN Switches

Connects SMU, 40GbE LDN, and 48-port LMN switches.

Cable SMU and 24-Port Omni-path LDN with Dual 24-Port LMN Switches

Connects SMU, Omni-Path LDN, and 24-port LMN switches.

Cable SMU and 24-Port Omni-path LDN Dual 48-Port LMN Switches

Cable SMU and Omni-path 48-Port LDN with Dual 24-Port LMN Switches

Cable SMU and 36-Port 100 GbE LDN with Dual 24-Port LMN Switches

Cable SMU and 36-Port 100 GbE LDN with Dual 48-Port LMN Switches

Power On the ClusterStor L300 and L300 N System

Prerequisites

System access requirements for powering on the system.

Required Tools and Equipment

Lists tools and equipment for powering on the system.

About this task

Explains the procedure for powering on the system.

Perform the First-Run Configuration

Create the Administrator Password

Procedure to set the initial administrator password.

Configure the Lustre Network Interfaces

Process for setting up network interfaces, DNS, and NTP.

Troubleshoot the Lustre Users Screen

Resolves errors during Lustre user authentication setup.

Post-Install Checkout

Performs final checks after installation.

Test Client Mount of Lustre File System

Verifies Lustre file system mounting for clients.

Configure SMTP Relay, RAS Email, Remote Support, and Service Console

Prerequisites

Configure SMTP