BIOREMEDIATING parts washing system
®
USER INSTRUCTION MANUAL
ORIGINAL INSTRUCTIONS
page 12 of 80
7.1.2. Model SW-25
1.
Remove the OzzyMat
®
from its package, unfold it and
lay it on the mat support grid located in the lowest
level in the sink. Make sure to lay the OzzyMat
®
white side up.
2. Place the false bottom in position in the sink.
3.
Form the flexible nozzle to its desired shape
and be sure that the parts brush is inside the sink
4.
DO NOT PLUG UNIT IN BEFORE
ADDING OZZY JUICE
®
5.
At start up, carefully add ± 95 liter of
OzzyJuice
®
to the SmartWasher
®
by slowly pouring
the solution directly into the sink.
6.
Plug the unit into a 220 VAC GFCI electrical
outlet
7.
The SmartWasher
®
will take approximately four hours
to heat up to its selected optimal temperature of
40°C (± 1°) or 46°C (± 1°). This temperature will be
maintained as long as the SmartWasher
®
is plugged
in and full of OzzyJuice
®
. (If the Add Fluid Light is on,
the heater automatically shuts o)
33075
Drain Basket 3 1/2”
32950
Multi-Layer OzzyMat
FL-4
33052
False Bottom With
Drain For Sink
33076
Mat Support Grid
To Next Page
Loading...
Need help?
General
