CRC Smartwasher SW-37 User Manual

Smartwasher SW-37
Operating Manual
|
9
If excessive oil is dumped into the SmartWasher
®
, take the following
steps to remedy the situation;
Issue - Excessive Oil Dumped in System
1. Unplug the SmartWasher
®
and lift the sink o the base.
2. Skim excessive oil o the top of the OzzyJuice
®
or place
an absorbent pad on top of the uid, soak up the oil and
dispose of it in accordance with local regulations.
3. In extreme cases, it may be necessary to replace
all of the OzzyJuice
®
in the SmartWasher
®
. Dispose
of contaminated OzzyJuice
®
and OzzyMats
®
according
to local regulations.
4. If you replace all of the OzzyJuice
®
, rinse the base of the
SmartWasher
®
to remove all excess oil and dirt.
5. Once unit has been cleaned, replace the sink and add a new
OzzyMat
®
and 100L ( 5 x 20L containers) of new
OzzyJuice
®
.
Issue - Excessive Fluid Loss
With “normal usage” you should have to add a 20L container of
OzzyJuice
®
approximately every 6 to 8 weeks.“Normal usage”
means the equivalent of several users in a 10 hour day in a standard
maintenance, repair and operation facility or several users in a
multiple bay garage facility.
Trouble Shooting
Cold OzzyJuice
®
Issue - COLD FLUID
THE HEATER AUTOMATICALLY SHUTS OFF.
Check to see if the “Add Fluid” indicators are lit. There should be
approximately 28 cm of uid in the machine when it is low.
If the “Add Fluid” light is lit, add a full 20L container of OzzyJuice
®
(the
light should go out). Allow for a reasonable warm up period and then
recheck.
Overheated OzzyJuice
®
Issue - OVERHEATED FLUID
If the uid becomes extremely hot and exceeds 49°C unplug the
SmartWasher
®
and call CRC Technical Support on 09 272 2700.
OzzyJuice
®
Discolouration Or Odour
Issue - FLUID DISCOLOURATION OR Odour
OzzyJuice
®
may become dark in colour due to dyes in oils or greases
removed from dirty parts. This will not aect its cleaning power. If the
uid should develop a strong odour, it may be contaminated and you
should call CRC Technical Support on 09 272 2700 for assistance in
diagnosing the problem.
Spilled OzzyJuice
®
Issue - FLUID SPILLAGE ONTO FLOOR
OzzyJuice
®
will cause the oor to become slippery. Use caution
when walking in or near spilled uid. To clean up an accidental spill
of new, unused uid simply soak up the solution with an absorbent
material, (or wash spillage down the nearest sanitary sewer). If the
spilled OzzyJuice
®
has been used, you must dispose of the spillage
in accordance with local regulations. If left to dry, the uid will leave a
tacky spot on the oor that when wet, will again become slippery.
SORT IT
The Thermostat is factory-set to maintain the
uid at 40°C or 46°C (+-1°).
For technical support visit our website www.crcind.com.au/smartwashe
r or call us on 1800 224 227

CRC Smartwasher SW-37 Specifications

General

Brand	CRC
Model	Smartwasher SW-37
Category	Washer
Language	English