14
Indicator Status and Exception Handling
Indicator status:
1) Light off: The machine is in a power-off state, or the power is abnormal.
2) Breathing light: The machine is in standby mode; you can press the microswitch to
enter preview mode or engraving mode.
3) Light flashes: the machine is in upgrade mode or abnormal mode, and the buzzer
beeps rapidly, and it will automatically enter standby mode after the upgrade is
completed or the abnormality is cleared.
4) Light always on: the machine is in preview mode or engraving mode. The laser head is
working, please pay attention to safety.
Exception Handling
1. In preview mode and engraving mode, if the machine turns on it side or moves, it will
turn off the laser. Motor stops moving, flash indicator light, and buzzer emits alarm.
Solution: Please move the machine to its original position and press microswitch on the
machine control box to continue previewing or engraving after clearing abnormality.
User Operation Guide
• Start
• Place engraving material
• Adjust the focal length of the laser module
• Prepare engraving files and insert TF card
• Power on
• Machine resets
• Wait for the machine to complete resetting
• Press microswitch
• Frame preview
• Press microswitch
• Start engraving, press function key
o Short press: Pause
▪ Yes: Continue engraving
▪ No: Engraving paused
o Long press: Stop engraving
o End
To Next Page
Loading...
Need help?
General
