Notice for Canada
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science
-exempt RSS(s). Operation is subject to the following
two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired
operation of the device.
appareil est conforme aux CNR
exempts de
compromettre le fonctionnement.
Canada Radiation Exposure Statement
This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled
environment. This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
-102 établies pour un
environnement non contrôlé. Cet émetteur ne doit pas être situé ou fonctionner conjointement avec
une autre antenne ou un autre émetteur.
MODIFICATION: Any changes or modifications not expressly approved by the grantee of this device
could void the user's authority to operate the device.
RF Exposure Statement
This equipment should be installed and operated with minimum distance 0cm between the radiator &
your body.
Cet équipement doit être installé et utilisé à une distance minimale de 0 cm entre le radiateur et votre
corps.
Specific Absorption Rate (SAR) information:
This USB meets the government's requirements for exposure to radio waves. The guidelines are based
on standards that were developed by independent scientific organizations through periodic and
thorough evaluation of scientific studies. The standards include a substantial safety margin designed to
assure the safety of all persons regardless of age or health. ISED RF Exposure Information and
Statement the SAR limit of Canada (ISED) is 1.6 W/kg averaged over one gram of tissue. Device types:
USB has also been tested against this SAR limit. This device was tested for typical body-worn
operations with the back of the USB kept 0mm from the body. To maintain compliance with ISED RF
exposure requirements, use accessories that maintain an 0mm separation distance between the user's
body and the back of the USB. The use of belt clips, holsters and similar accessories should not contain
metallic components in its assembly. The use of accessories that do not satisfy these requirements
may not comply with ISED RF exposure requirements, and should be avoided.
To Next Page
Loading...
