Creative Sound Blaster Live! - Page 29

B-6 SB16 Emulation in MS-DOS/ Windows 95/98
To set
SBEMIXER
values in the command
line:
At the DOS prompt, type the
SBEMIXER
command in a single line. Its syntax is:
SBEMIXER
[/S:
x
] [/W:
x
] [/C:
x
] [/M:
x
] [/?]
where
• Square brackets [ ] denote optional
parameters
This
Parameter Specifies
/S:
x
Synth volume.
x
can be a
value from the range 0 to 127.
/W:
x
Wave volume.
x
can be a
value from the range 0 to 127.
/C:
x
CD audio volume.
x
can be a
value from the range 0 to 127.
/M:
x
Synth MT-32/LAPC-1 mode.
For
x,
0 is Off, 1 is On.
/? View a short description of
the parameters.
An example of an
SBEMIXER
command is
SBEMIXER /S:64 /W:120 /C:50 /M:0
which corresponds to “set the synth volume to
64, the Wave volume to 120, the CD audio
volume to 50, and turn off the Synth
MT-32/LAPC-1 mode”.
To set
SBEMIXER
values within the Mixer
screen:
At the DOS prompt, type the
SBEMIXER
The interactive editor mode allows you to
change the mixer settings with the mouse,
<Tab>, <PgUp>, <PgDn>, or arrow keys.
Use the Save button to save the settings for the
next session.
SBEGO.EXE
Use this to confirm whether SB16 Emulation
is properly installed and working.