Creative ZiiSound D5x - Linking ZiiSound Speakers; Adding a Subwoofer for 1.1 System

11
1.7
Switching between paired devices
Enjoyyourfavouritemusicfromanotherpaired Bluetooth device by following these steps to establish
the connection.
2.1
Adding a subwoofer to the D5x to form a 1.1 speaker system
Section 2 : Linking with another ZiiSound D5x or DSx Wireless subwoofer
Action LED status Status
_
Press“CONNECTTouchpad/Button”once
_
CONNECTLEDblinksand
stays lit
Ensurethatthenext
previously paired device has
Bluetooth powered on and
ready to accept connection
Bluetooth connection
switches.Readytostream
music.
Note:Itisneccessarytoclearthememoryoflinkedspeakers(allD5x(s)andDSx)shouldyou
requiretocongureanewsetup.(Forexample,addinganotherD5xorDSx)
ProceedtoStep(b)ifyourD5xorDSxhavenotbeenlinkedwithotherspeakerbefore.
IfyourD5xorDSxhavebeenlinkedbefore,followtheinstructionbelowtoclearlinksystem
memorytorecongureanewspeakersetup.
For the D5x(s)
Ensurethespeakerisinstandbymode.PressandholdthePowerON/Standbybuttonlocatedat
therearofthespeakeruntilLINKandCONNECTLEDblinks2timesandgoesoff.TheD5xLink
memory has been cleared.
For the DSx
PressandholdtheLINKButtonlocatedattherearofthesubwooferfor10secondsuntiltheLink
LEDblinks2timesandgoesoff.TheDSxLinkmemoryhasbeencleared.
A