Creche Innovations MicroCool - Change Supervisor Code (Supervisor Code); Remove User Code (Supervisor)

7
Change the Supervisor Code (3-6 Digits) Using a Supervisor Code
1. Push the black program button 1 times
2. Enter old supervisor code 1 time
3. Enter new supervisor code 1 time
4. Press the black program button 1 time
5. The lock will blink 6 times to indicate that the old supervisor code was erased and
the new supervisor code was accepted
Remove the User Code Using the Supervisor Code
1. Push the black program button 2 times
2. Enter the supervisor code
3. Enter 1 1 1 1 1
4. Press the black program button 1 time
5. The lock will blink 6 times to indicate that the supervisor code was used to remove
the user code. The user code will no longer be valid for access.
Add a Control Fob
1. Push the black program button 1 time
2. Enter the master code
3. Point the control fob at the black program button and press the fob button
4. The lock will blink 6 times to indicate that the master code was used to add a
control fob
Add a Supervisor Code (3-6 Digits) Using the Control Fob
1. Push the black program button 1 time
2. Point the control fob at the black program button and press the fob button
3. Enter supervisor code
4. Push the black program button 1 time
5. The lock will blink 6 times to indicate that the supervisor code was used to add
a control fob
Add a Supervisor Fob Using the Master Code
1. Push the black program button 1 time
2. Enter the master code
3. Point the Supervisor Fob at the black program button and press the fob button
4. The lock will blink 6 times to indicate that the master code was used to add a
supervisor fob