Creche Innovations MicroCool - Station Mode Programming Instructions; Change Master Code (Factory Code); Change Supervisor Code (Factory Code); Add User Code (Supervisor)

6
3 Station Mode Programming Instructions
** Make sure to write down all the new codes you create for future use.**
Change the Master Code (6 Digits) using the Factory Master Code
1. Push the black program button (located on the side of the lock) 5 times
2. Enter the factory master code (135243) 2 times
3. Enter your new master code (must be 6 digits long) 2 times.
4. The lock will blink 6 times to indicate that the factory master code was erased
and your new master code was accepted.
Change the Supervisor Code (3-6 Digits) using the Factory Supervisor Code
1. Push the black program button 1 time
2. Enter the factory supervisor code (123) 1 time
3. Enter your new supervisor code (must be 3-6 digits long) 1 time
4. Push the black program button 1 time
5. The lock will blink 6 times to indicate that the factory supervisor code was erased
and your new supervisor code was added.
Add a User Code (3-6 Digits) using the Supervisor Code
1. Push the black program button 2 times
2. Enter your supervisor code 1 time
3. Enter the new user code 1 time
4. Push the black program button 1 time
5. The lock will blink 6 times to indicate that your supervisor code was used to add
the new user code
Change your current Master Code (6 Digits)
1. Push the black program button 5 times
2. Enter old master code 2 times
3. Enter new master code 2 times
4. The lock will blink 6 times to indicate that old master code was erased and
new master code was accepted.