CREE LIGHTING CONNECTED MAX - Attach your Tape Lights

4
Attach your Tape Lights
Clean the surface with a
wet, damp cloth. Surface
must be dry and free of
dirt or oils.
Peal off the backing
strip from the
adhesive.
Place the Tape
Light Strip where
you want, and
gently press down
to adhere.
Do NOT bend Tape
Light Strip at LED or
connection when going
around corners.
Do NOT bend at more
than a 90° angle.
Connect the Tape
Light Strip into the
Controller and Wall
Plug. Use the supplied
Adhesive Pad to
secure the conroller.
3
1
2
4
<90°
LED
5