22
LED INDICATOR SAFETY (FAULT)
LED will flicker if a mistake occurred in the amplifier installation and will light up continuously
if amplifier is broken. Look at Figure 5.
Note :
Take away all the wiring from the amplifier and check one by one. Make sure the mistake
was found before re-installing cable to the amplifier.
Figure 5
WIRING ILLUSTRATION
1. CRESCENDO EVOLUTION SEVEN 7A6 is connected to 3 ways speaker system with bi-wire
(2 input) passive crossover and 1 subwoofer in bridged mode. Look at Figure 6.
2. CRESCENDO EVOLUTION SEVEN 7A6 is connected to 3 ways speaker system and 2
subwoofers in mono mode. Look at Figure 7.
3. CRESCENDO EVOLUTION SEVEN 7A6 is connected to 2 sets of 3 ways or 2 ways speaker
system and 2 subwoofers in stereo mode. Look at Figure 8.
4. CRESCENDO EVOLUTION SEVEN 7A6 is connected to 3 ways speaker system with full active
crossover. Look at Figure 9.
5. CRESCENDO EVOLUTION SEVEN 7A6 is connected to 3 ways speaker system with passive /
active crossover combination and 2 subwoofers in stereo model. Look at Figure 10.
To Next Page
