Assembly Method
●Pull up the handle bar as arrow showed , there is “click “ voice
after unfold the frame (Figure 1).
●Put the rear wheels into the axle hole until fully plug in (Figure 2).
●Adjust the backrest to the most upright position as (Figure 3).
●Put the seat into joint holder of stroller frame(Figure 4).
4
4
2
①
②
3
1
①
②
assembly method
• Pull up the handle bar as arrow showed, there is “click “ voice after unfold the frame
(Figure 1).
• Put the rear wheels into the axle hole until fully plug in (Figure 2).
• Adjust the backrest to the most upright position as (Figure 3).
• Put the seat into joint holder of stroller frame(Figure 4).
To Next Page
Loading...
