cressi.com
NUMBER OF DIVING ALARM FOR FREE AND PRO PROGRAMS.
An alarm that alerts that a certain number of dives has been reached can be convenient for training
purposes or not to become tire.
To set the alarm scroll with UP or DOWN buttons until the ALARMS menu. Enter the menu by pressing the
MODE button. The numbers in the top left of the display below the TR indicator will flash. Press the UP or
DOWN button until the value at the bottom left of the display marked with the icon of the gate flashes.
Press the MODE button again. The display shows just the highlighted item, flashing. Set the desired value
by pressing the UP or DOWN buttons. Confirm the set value by holding down the Mode button for a few
seconds until hearing an acoustic signal to confirm the exit from the menu. Alternatively, after the last time
the buttons are pressed, the computer will modify the automatic setting by issuing an acoustic signal to
return then to the main screen, and then it will automatically shut down.
Once the alarm has been set, the computer will indicate that the number of dives inserted has been
reached by flashing the data related to dives performed, accompanying it (if the audible alarms are set)
with an audible alarm.
SETTING ACOUSTIC ALARMS FOR ALL THE PROGRAMS
There are diving disciplines where a sound alarm is necessary to keep higher concentration or where a
sound alarm can be more counter-productive than an aid. For these reasons, Drake allows the activation
or deactivation of the acoustic alarms according to the selected activity. Activating the acoustic alarms,
Drake will accompany each alarm previously entered with an audible signal. Otherwise Drake will eliminate
this acoustic signal to all active alarms in the current program.
To set the alarm scroll with UP or DOWN buttons until the ALARMS menu. Enter the menu by pressing the
MODE button. The numbers in the top left of the display below the TR indicator will flash. Press the UP or
DOWN button until the word BUZZ in the bottom right flashes. Press the MODE button again. The flashing
words ON or OFF will appear on the display. Change the words using the UP or DOWN button but
remember that in case of ON, the alarms will be activated while in case of OFF, the alarms will be
deactivated. Confirm the activation by holding down the Mode button for a few seconds until hearing an
acoustic signal to confirm the exit from the menu. Alternatively, after the last time the buttons are pressed,
the computer will modify the automatic setting by issuing an acoustic signal to return then to the main
screen, and then it will automatically shut down. The condition of the acoustic alarms is shown by the bell
icon that, in case of active acoustic alerts, will always be at the bottom of the display.
SETTING SEA WATER OR FRESH WATER FOR FREE AND PRO PROGRAMS.
Setting sea water or fresh water has a particular importance for an accurate and correct indication of the
depth. In fact, the density of the two types of water is not the same and this can cause discrepancies
between the actual depth and that indicated by the computer.
To set the type of water scroll with the UP or DOWN buttons until the ALARMS menu. Enter the menu by
pressing the MODE button. The numbers in the top left of the display below the TR indicator will flash.
Press the UP or DOWN button until the word SALT flashes on the bottom right.
Press the MODE button again. The flashing words ON or OFF will appear on the display. Change the word
using the UP or DOWN button but remember that in case of ON, sea water will be set while in case of OFF,
fresh water will be set. Confirm the activation by holding down the Mode button for a few seconds until
hearing an acoustic signal to confirm the exit from the menu. Alternatively, after the last time the buttons
are pressed, the computer will modify the automatic setting by issuing an acoustic signal to return then to
the main screen, and then it will automatically shut down.
ALARMS: NUMBER OF DIVING ALARM FOR FREE AND PRO PROGRAMS
To Next Page
Loading...
