Cressi ISUP - Pump and Valve Operation; Manual Pump Usage; HP Valve Operation

7
1
To inate the SUP, make sure to correctly connect the hose to the manual pump, clockwise until
tight (Fig. 1). Manual pumps have two connections, one for inating and one for deating (Fig. 2).
Be sure to fasten the hose to the correct connection.
Turning the switch (Fig. 3) to the right activates the pump’s double action. This is useful for
speeding up the rst stage of the ination. Turning the switch to the left activates the single
action mode, which is ideal for facilitating higher pressure ination.
SINGLE
ACTION
DOUBLE
ACTION
Manual pump
2
Switch
3
Double air chamber models, equipped
with two valves: at the end of the pad
and at the stern.
Double Chamber ISUP
1
2
Position of the valves and ination sequence
Single air chamber models, equipped
with a valve at the stern.
Single Chamber ISUP
1
The HP valve is a high-pressure valve. To inate, unscrew the upper cap counterclockwise (Fig.
1). Make sure that the central pin is in the raised position. Insert the end of the ination tube all
the way in, and twist it clockwise (Fig. 2). When you're done inating, screw the cap back on. To
deate the air chamber quickly, rmly press the pin to the lowered position (Fig. 3).
Deation
HP Valve
21
Ination
3