Crest Audio CKI - Removable Attenuator Knobs

p.18
Operation
5
IGM
Protect
AB
ACL
Signal
Ch BCh A
Input
+
Gain
(.775V)
0dB
x40x20
+
Mode
Stereo
ParallelBridge
Active
+
AB
A B
+
+
Output - Class 2 Wiring
In Out
On
Com
Off
On
Com
Off
Fault
N/O
Com
N/C
Gnd
In
Sequential Turn-On
Input
V-In
Crest Audio, Inc.
Fair Lawn, NJ USA
www.crestaudio.com
Designed and manufactured in the USA by:
3.3V
Out
Ch B
-30
-6
-1
dB
Ch A
-3
-10
-15
-
-30
-6
-1
dB
-3
-10
-15
-
Edit FunctionSelect
I.P. Address
AC Voltage
Temperature
Gain
Amp ID
Mute
Fault
Data
Link
AB
Nx Ethernet
Ethernet
+
Ch. B
+
Ch. A
CV Line Ch. B
CV Line Ch. A
IGM
Protect
AB
ACL
Signal
Ch BCh A
Input
+
Gain
(.775V)
0dB
x40x20
+
Mode
Stereo
ParallelBridge
Active
+
AB
A B
+
+
Output - Class 2 Wiring
In Out
On
Com
Off
On
Com
Off
Fault
N/O
Com
N/C
Gnd
In
Sequential Turn-On
Input
V-In
Crest Audio, Inc.
Fair Lawn, NJ USA
www.crestaudio.com
Designed and manufactured in the USA by:
3.3V
Out
Ch B
-30
-6
-1
dB
Ch A
-3
-10
-15
-
-30
-6
-1
dB
-3
-10
-15
-
Edit FunctionSelect
I.P. Address
AC Voltage
Temperature
Gain
Amp ID
Mute
Fault
Data
Link
AB
Nx Ethernet
Ethernet
+
Ch. A
CV Line Ch. B
CV Line Ch. A
Stereo Mode
Constant Voltage Output (V & X Models only)
Parallel Mode
Constant Voltage Output (v & x Models only)
Removable Attenuator Knobs
The attenuator knobs can be removed and replaced with plugs that are
shipped with the amplifier.The procedure for attenuator knob removal is as fol-
lows:
1.With a small knife, remove the gray key cap of the attenuator knob
revealing the inside nut.
2.Using needle nose pliers or an appropriately sized nut driver,loosen
the nut.
3.Slide the attenuator knob off the shaft.
4.Insert a regular screwdriver in the slotted end of the shaft and adjust
attenuation to the desired level.
5.Insert the blank plugs into the attenuator holes.
llel
Ch B
-30
-6
-1
dB
Ch A
-3
-10
-15
-
-30
-6
-1
dB
-3
-10
-15
-
Ch.A - Knob still attached
Ch.B - Knob replaced with plug