Front panel features
EQ
Many audio signals coming into the console require some degree of corrective eq
in order to be part of a good sounding mix. XR-20 & XR-24 offer a very useful
and great sounding eq section on each channel. The input EQ consists of four
bands: High, High-mid, Low-mid and Low. The High and Low frequency bands each
have a boost/cut control and their frequencies are fixed. The High-mid and Low-
mid bands each have variable boost/cut and variable frequency.
high frequency—HF
Boost / Cut15dB boost and cut. Shelving @ 12 kHz
high mid—HM
FrequencyContinuously sweepable between 400 Hz and 8 kHz.
Boost / Cut15dB boost and cut. Bell curve with a Q of 1
Low mid—LM
FrequencyContinuously sweepable between 100 Hz and 2 kHz.
Boost / Cut15dB boost and cut. Bell curve with a Q of 1
Low frequency—LF
Boost / Cut15dB boost and cut. Shelving @ 80 Hz.
EQ on
Equalizer is on. This switch is used to activate the EQ section and can be
used to make A/B comparisons between "flat" and eq'd signals.
p.9
Mono Input channel
1
To Next Page
Loading...
