Front panel features
MONITOROutput section
SOURCESELECT
The Source select portion of the Monitor system allows you do assign the prima-
ry mix buses to the Monitor outputs. All assignments are post insert, pre-fader. All
selected sources are added (summed) together.
TAPEIN
Assigns the TAPEINL & R signals to the monitors. The TAPEINjacks are
located on the rear panel. 1/4” TRSjacks and RCAphone plugs are provided for
easy hookup.
A1-2 (Aux 1 & 2)
Assigns Auxes 1 and 2 to the Monitor outputs. Auxes 1 and 2 are config-
ured as one stereo Aux bus (see Mono input channel description). 1 is Left and 2
is Right.
MONO
Assigns the Mono bus to both the Left and Right Monitor outs.
L-R (Left & Right)
Assigns the Left and Right buses to the Left and Right Monitor outs.
G1-2 (Groups 1 & 2)
Assigns Groups 1 and 2 to the Monitor outs.1 is Left and 2 is Right
G3-4 (Groups 2 & 4)
Assigns Groups 3 and 4 to the Monitor outs. 3 is Left and 4 is Right.
Master section
3
p.37
To Next Page
Loading...
