NOTES:
NOTES:
NOTES:
NOTES:
• First insert the batteries of main unit, then insert the batteries of the outdoor sensor in 3
minutes after the main unit is powered on, to assure of the sensor data received well.
In case of the outdoor sensor data received failure, pls press ␇
␇
␇
␇ key for more than 3
seconds to synchronize the RF signal.
• Every time the batteries are replaced , the main unit will loose all the weather data.
•
Every time the batteries are replaced , the thermo-hygro sensor will sychronize with the main
u nit again , you must press the ␇
␇
␇
␇ key for more than 3 seconds to synchronize the RF signal.
•
•
•
• Mounting
Mounting
Mounting
Mounting the
the
the
the main
main
main
main unit
unit
unit
unit
The main unit can be placed onto any flat surface or wall mounted at the desired location by
h anging hole, It is important to check that the radio signal can be received before mounting.
•
•
•
• Mounting
Mounting
Mounting
Mounting the
the
the
the outdoor
outdoor
outdoor
outdoor sensor
sensor
sensor
sensor onto
onto
onto
onto the
the
the
the stainless
stainless
stainless
stainless steel
steel
steel
steel mast
mast
mast
mast
For accurate results, the outdoor sensor mast should be securely mounted onto a horizontal
surface and in an open area away from trees and other coverings where rainfall or wind
speed may be reduced causing inaccurate reading.
1. Mounting
Mounting
Mounting
Mounting the
the
the
the wind
wind
wind
wind speed
speed
speed
speed sensor
sensor
sensor
sensor to
to
to
to the
the
the
the first
first
first
first plastic
plastic
plastic
plastic bracket
bracket
bracket
bracket ： first check the wind-fan
can rotate freely before fixing . The wind speed sensor should now be mounted onto the
bracket provided to allow the wind to travel around the sensor unhindered from all
directions.please follow the below display :
To Next Page
Loading...