Crestron CENI-GWEXER - DIN Rail Mount; Installation

Installation
Mount the CENI-GWEXER to a DIN rail or a wall. The CENI-GWEXER can
also be rack mounted. Refer to the RMK-IFE-1U Installation Guide
(Doc.7627) at www.crestron.com/manuals for details. It can also be
placed on any flat, level surface.
NOTES:
l This product must be installed and used in accordance with
appropriate electrical codes and regulations.
l This product must be installed by a qualified electrician.
DINRail Mount
1. Hang the mounting bracket on the top of the DIN rail and press the
bottom toward the DIN rail until it snaps into place.
2. Insert the CENI-GWEXER into the mounting bracket until it snaps into
place.
3. Secure the CENI-GWEXER to the mounting bracket. Insert a
6-32x3/8in. screw into each side of the mounting bracket and tighten
using a Phillips screwdriver.
NOTE: Do not use the included screws to mount the bracket to the
bottom of the CENI-GWEXER, as it will then not be possible to
remove the device from the DIN rail.
2
CENI-GWEXER and CENI-GWEXER-PWE
QuickStart
Wireless Gateway, infiNETEX®Wireless and ERWireless, International Version