Crestron CENI-GWEXER - Wall Mount; Make Connections

Wall Mount
1. Secure the mounting bracket to a vertical, flat surface using screws
that are appropriate for the mounting surface (not included).
2. Insert the CENI-GWEXER into the mounting bracket until it snaps into
place.
3. Secure the CENI-GWEXER to the mounting bracket. Insert a 6-32 x
3/8 in. screw into each side of the mounting bracket and tighten using
a Phillips screwdriver.
Make Connections
Make the necessary connections for your application. Turn on power to
the CENI-GWEXER after all connections have been made. Use Crestron
power supplies for Crestron equipment.
l When PoE is not available, supply power using a Crestron power
supply such as a PW-2407WU (not included).
l When a Crestron PoE switch is available, connect the Ethernet cable
directly to the PoE switch.
l When using a Crestron PoE injector:
o
Connect the CENI-GWEXER to the PoE injector:
n Connect the CAT5e cable (supplied) to the LAN PoE port on the
CENI-GWEXER.
n Connect the other end of the CAT5e cable to the LAN PoE port
on the PoE injector.
3
CENI-GWEXER and CENI-GWEXER-PWE
QuickStart
Wireless Gateway, infiNETEX®Wireless and ERWireless, International Version