Need help?Do you have a question about the Crestron Ethernet and is the answer not in the manual?
Guide to installing the necessary software for eServer setup.
Instructions for physically connecting the eServer to a PC.
Steps to configure the eServer's IP address using Viewport.
How to connect the eServer to the local network via Ethernet.
Instructions on accessing the preloaded demonstration on the eServer.
Detailed explanation of the eServer's functionality and architecture.
Illustrations showing the physical layout and dimensions of the eServer.
Details on the DC power socket and required power pack specifications.
Information about the 9-pin connector for serial equipment control.
Detailed pin configuration for the DEVICE serial port.
Detailed pin configuration for the COM IN serial port.
Pin configuration for the RJ45 Ethernet port.
Explains the PWR LED status for power supply.
Describes LEDs for Ethernet data reception, transmission, link, and errors.
Explains LEDs for device data reception, transmission, and pass-through.
Deciding between Crestron and non-Crestron control interfaces.
Using a web browser for direct control of a device via the eServer.
Understanding the CEN-OEM symbol for eServer integration.
How SIMPL+ programs interpret data for the eServer.
Table of common troubles, causes, and corrective actions.
Process for returning products for credit, exchange, or service.
Extended warranty information for Crestron products.
Definitions for Browser, CIP, CNX Control System, CNX Gateway, Default Router.
Definitions for Graphical User Interface and HTML.
General| Brand | Crestron |
|---|---|
| Model | Ethernet |
| Category | Network Card |
| Language | English |
To Next Page