DO GUIDE
DO Check the Box
QTY PRODUCT COLOR PART NUM.
1 Cable Mount Ferrite Bead 2033216
1 Mounting Bracket 4516761
4 Screws, 06-32 x 3/4", Undercut Head, Phillips 2033247
4 Screws, 3 x 16 mm, Flat Head, Phillips 2013788
For European-style installations, use the 3 x 16 mm screws.
2. Make connections to the TSW-752 using Crestron power supplies for Crestron equipment.
Apply power after all connections have been made.
NOTE: The included cable mount ferrite bead, FBTH-2, should be placed on the LAN
cable in the electrical box.
3. Carefully hold the touch screen over the mounting bracket and gently place it in position.
The magnets on the rear of the touch screen hold it in place on the mounting bracket.
DO Connect the Device
Connect the TSW-752 to the LAN as shown in the following illustration.
TSW-752
7" Touch Screen
DO Install the Touch Screen
The Crestron
®
TSW-752 touch screen installs easily over a standard 2-gang or 3-gang U.S.
electrical box or over a 2-gang European electrical box. It can also be attached directly to
drywall and other surfaces over the front of a 2 3/8” (60 mm) high by 3 3/8” (86 mm) wide cutout.
When installed, the touch screen protrudes just 1/2” (13 mm) from the mounting surface and is
magnetically adhered to its mounting bracket, eliminating any visible screws for an ultra clean
appearance.
NOTE: For proper positioning of the touch screen, the electrical box or cutout must be
positioned approximately 1/4” (6 mm) to the right of the touch screen’s center and 1/10” (3 mm)
above its center.
To mount the TSW-752 into an electrical box, use the following procedure:
1. Use four of the eight included screws (four 06-32 x 3/4” or four 3 x 16 mm screws) to attach
the mounting bracket to the electrical box, as shown in the following illustrations.
NOTE: For U.S.-style installations, use a #2 Phillips screwdriver. For European-style
installations, use a #1 Phillips screwdriver or equivalent.
For U.S.-style installations, use the 06-32 x 3/4” screws.
To Next Page
Need help?
General
