CREVIS NA-9171 - User Manual

Questions and Answers

C
Christine SantanaAug 13, 2025
Why is the NET LED on my CREVIS Adapter red?
- K
  Katelyn RobertsAug 13, 2025
  A red NET LED on your CREVIS Adapter indicates a communication connection has been lost. Check the BUS line cable for connection with the master. Also, check for a duplicate address.
R
Raymond AriasAug 16, 2025
What to do if I/O LED flashes red on CREVIS Adapter?
- B
  Beth DoyleAug 16, 2025
  If the I/O LED on your CREVIS Adapter flashes red, there may be a failure in the configuration baud rate, a failure of initialization I/O, or the NA series may notice an unidentified expansion module ID. Check the communication cable with the master and the power for the master. Also, use an expansion slot of up to 32 and compose the IO total size so that it is not excessive. Finally, check the status of the expansion module.
M
Mary StanleyAug 20, 2025
How to fix NET LED when it turns off on CREVIS Adapter?
- S
  Sonya CastanedaAug 20, 2025
  If the NET LED turns off, it indicates a failure of communication with the Master. Check the main power for the master and the communication cable.
C
Cindy GarzaAug 25, 2025
What does it mean when all LEDs turn off on CREVIS Adapter?
- R
  Roger SmithAug 25, 2025
  If all LEDs turn off on your CREVIS Adapter, it could mean there is no power. Check the main power cable. If power is present, it could indicate that the system power is not supplied, in which case you should contact the sales team and send the module for repair.
G
garyboydAug 28, 2025
What does it mean when MOD LED flashes red on CREVIS Adapter?
- A
  amyschultzAug 28, 2025
  If the MOD LED on your CREVIS Adapter flashes red, it could be due to an excess of expansion slot, an excess of IO size, a wrong IO composition, or an occurrence of an EEPROM checksum error. Use an expansion slot of up to 32. Compose the IO total size so that it is not excessive. Check the composition of the I/O Module.
A
Adam WalkerSep 1, 2025
What does it mean when the NET LED flashed green on CREVIS Adapter?
- K
  kristinasmithSep 1, 2025
  If the NET LED flashes green, it indicates a failure of exchanging data with the master. Check the status in the software for the Master configuration.
J
jennifersmithSep 4, 2025
Why is the I/O LED red on my CREVIS Adapter?
- R
  Rebecca PrestonSep 4, 2025
  If the I/O LED is red, it indicates a failure of exchanging I/O data. Check the status of the expansion IO connection.
A
angelaelliottSep 8, 2025
What to do if I/O LED turns off on CREVIS Adapter?
- J
  jasonwilsonSep 8, 2025
  If the I/O LED turns off, it indicates a failure of realization of the expansion Module or that there is no expansion Module. Check the connector status of both the NA series and the expansion module.