Maintenance
Disposal
Maintenance Changing the Internal Light
1. Before carrying out the bulb replacement always adjust the thermostat control dial to
Position 0, then disconnect the mains supply.
2. Use a at bladed screwdriver and gently pry off the light bulb cover.
3. Remove the old bulb by unscrewing in an counter clockwise direction.
4. Replace with a new bulb (10W SES).
5. Ret the light bulb cover and reconnect the unit to the mains supply and switch on by
adjusting the thermostat.
Care When Handling
Hold the unit around its sides or base when moving it. Under no circumstances should
it be lifted by holding the edges of the top surface.
Servicing
The unit should be serviced by an authorized service and only genuine spare parts
should be used. Under no circumstances should you attempt to repair the unit yourself.
Repairs carried out by inexperienced persons may cause injury or serious malfunction.
Contact a qualied technician. For information call 1-866 915 1212 and you will be
advised.
Switching Off for Long Periods of Time
When the unit is not in use for a long period of time, disconnect it from the mains supply,
empty all food and clean the appliance, leaving the door ajar to prevent unpleasant
smells.
Old units still have some residual value. An environmentally friendly method of
disposal will ensure that valuable raw materials can be recovered and used again.
The refrigerant used in your unit and insulation materials require special disposal
procedures. Ensure that none of the pipes on the back of the unit are damaged prior
to disposal.
Up to date information concerning options of disposing of your old unit and packaging
from the new one can be obtained from your local council ofce.
When disposing of an old unit break off any old locks or latches and remove the door
as a safeguard.
To Previous Page
Loading...
