39
Cooktop
Oven
Problem Possible Cause Solution
Heating elements and controls
do not work.
· Fuse is blown or circuit
breaker is tripped.
· No electricity to the cooktop.
· Replace the fuse or reset the circuit
breaker. If the problem continues, call an
electrician.
· Have electrician check your power
supply.
Heating elements do not heat
properly.
Improper cookware is being
used.
· Select proper cookware. See
"Cookware".
· If the problem continues, call for
service.
Heating elements cycle o
even when elements are
turned to their highest settings.
Heating element temperature
limiters are temporarily
shutting o the elements due
to exceeding the maximum
allowable temperature.
This is a normal operating condition,
especially during rapid heat-up
operations. The element will cycle back
on automatically after it has cooled
suciently.
Glass ceramic surface is see
through or appears to be red in
color.
Under direct or bright lighting,
you will sometimes be able
to see through the glass and
into the chassis due to its
transparent quality. You may
also notice a red tint under
these conditions
These are normal properties of black
ceramic glass panels.
Problem Possible Cause Solution
Oven is not heating
No power to the oven Replace the fuse or reset the circuit
breaker. If the problem continues, call an
electrician.
Oven control not turned on Make sure the oven temperature has
been selected.
Oven door is not closed. Close the oven door. The heating
elements turn o when the door is
opened and remain o until the oven
door is closed.
Oven is not cooking evenly
Not using the correct bake ware
or oven rack position
Refer to cook charts for recommended
rack position. Always reduce recipe
temperature by 25 °F (15 °C) when
baking with Convection Bake mode.
To Next Page
Loading...