Criterion CRH160C1W - User Manual

Questions and Answers

B
Bryan WintersAug 10, 2025
What to do if the fan in my Criterion CRH160C1W Ventilation Hood is not spinning?
- L
  Lori CervantesAug 10, 2025
  If your Criterion Ventilation Hood fan is not spinning, stuck, or rattling, it could be due to a few reasons. The thermal protection system may have detected that the motor is too hot and shut it down; in this case, the motor will function properly after it cools down (approximately 10 min). Also, check that the fan isn’t jammed or scraping the bottom. If these steps don't resolve the issue, the motor may be defective and need to be replaced.
N
nwalkerAug 15, 2025
How to fix a Criterion CRH160C1W that does not operate?
- J
  Jacob SantiagoAug 15, 2025
  If your Criterion Ventilation Hood does not operate, check that the power supply cable and all electrical wiring are properly connected. Also, verify that the power is turned on at the junction box or circuit breaker. Finally, ensure that the wiring between the switch control and the control board are connected properly.
R
Rachel WhiteAug 20, 2025
Why do the fans on my Criterion Ventilation Hood seem weak?
- J
  Jennifer MayAug 20, 2025
  If the fans in your Criterion Ventilation Hood seem weak, check that the duct size used is at least 177 mm (7 in) round, as the hood will not function efficiently with insufficient duct size. Also, ensure that the duct is not clogged with debris and that the tight mesh on the wall cap, if applicable, isn’t restricting air flow. Check that the damper unit is opening properly and that no birds or animals have nested in the duct.
R
rodney41Aug 26, 2025
What causes a Criterion CRH160C1W Ventilation Hood to vibrate when the fan is on?
- C
  Chad WyattAug 26, 2025
  If your Criterion Ventilation Hood vibrates when the fan is operating, check that the hood has been secured properly and tighten it into position if necessary. Also, ensure that the motor is secured in place; if not, tighten the motor. Finally, check that the fan is not damaged; if it is, replace the fan.
A
Alfred SimsAug 30, 2025
How to troubleshoot a light that doesn't work in a Criterion Ventilation Hood?
- M
  Michelle CarpenterAug 30, 2025
  If a light in your Criterion Ventilation Hood does not work, first check if the light bulb is burnt and replace it if necessary. If the bulb isn't burnt, check if it is loose and tighten it. If the problem persists, remove the problem bulb and insert one you know is working. If the properly functioning light does not come on, the problem may be the light assembly, and you should have it serviced or replaced.
C
Curtis DonovanNov 4, 2025
Why is my Criterion CRH160C1W not venting properly?
- S
  Steven GriffinNov 5, 2025
  Several factors can cause a Criterion Ventilation Hood to not vent properly. Ensure that no birds or animals have nested in the duct. The distance between the cooktop and the bottom of the hood should be between 458 mm (18 in) and 710 mm (28 in). The duct work should follow all requirements, using round metal duct work with a uniform diameter of 177 mm (7 in), and should not exceed 35 ft (10.7 m). Reduce the length of duct work and the number of elbows if necessary, and ensure that all joints are properly connected, sealed, and taped. The duct should not open against the wind. For heavy cooking, ensure the power is on high speed. Close all windows nearest to the hood to eliminate sudden air gusts. To enhance performance, slightly open a window on the opposite side of the house where the ho...