Need help?Do you have a question about the CRL SM5C and is the answer not in the manual?
General| Brand | CRL |
|---|---|
| Model | SM5C |
| Category | Edger |
| Cutting Width | 5 inches |
| Blade Type | Steel |
Outlines warranty terms, buyer's remedy, and conditions for manufactured products.
Defines seller's liability for third-party equipment warranties.
Specifies seller's sole remedy and limits liability for consequential damages.
Details arbitration process and jurisdiction for dispute settlement.
States that contract and claims are governed by Illinois law.
Ensures remaining provisions are unaffected if any are found invalid.
Provides essential safety precautions for operating electrical equipment and maintaining a safe workspace.
Describes the main components of the edging machine setup, including conveyors and racks.
Details the recommended procedure for lifting and positioning the main machine using lifting rings.
Explains how to install and level the main machine and conveyors using adjustable feet.
Guides on connecting the machine to the power source, grounding, and wiring checks.
Instructions for connecting the water pump to the machine's power socket for cooling.
Details on connecting plastic tubing for coolant supply and drain lines.
Identifies the various components and controls on the machine's operating panel.
Explains the assembly structure and components of the grinding wheels.
How to adjust the grinding wheel positions using hand-wheels for optimal grinding.
Refers to main and control circuit diagrams for electronic system details.
Step-by-step guide for assembling the SM5C machine, including conveyors and supports.
To Next Page