Crofton VC9385S - Assembly; Before First Use; Preparing the Carpet Cleaner; Helpful Things to Think about before Carpet Cleaning

6
ASSEMBLY
 Insert handle into the Carpet Cleaner. Insert a screw into
the hole on each side of the handle. Tighten screws.
BEFORE FIRST USE
IMPORTANT: Do not use the Carpet Cleaner as a dry
vacuum.
 Vacuum the carpet thoroughly.
 Remove as much furniture from the room as possible. If
unable to remove the furniture, place plastic or foil under
and around furniture legs until the carpet has completely dried.
Check for Color Fastness:
Before cleaning carpet, test for color fastness. Dampen a white cloth with carpet
solution. Test a small area in an inconspicuous place. Gently rub over the area. Check
each color for color bleeding. If the cloth remains clean, it should be safe to clean the
carpet.
PREPARING THE CARPET CLEANER
 Hold the handle of the clean water tank and press
“Clean Water Tank Release”. Tilt clean water tank
away from the Carpet Cleaner and remove.
 Unscrew the tank cap from the bottom of the water
tank and fill with 2 teaspoons of cleaning solution.
 Fill the remainder of clean water tank with warm
tap water to the MAX line. Replace cap.
 Place bottom of clean water tank into the Carpet
Cleaner and push back until it locks into place.
NOTE: Any carpet cleaner solution available at your local retail or hardware store can
be used with this Carpet Cleaner. Please note you may need to modify the amount of
cleaning solution you use.
Helpful Things to Think About Before Carpet Cleaning:
 Before cleaning, determine where to start and end, making sure not to walk over
previously cleaned area.
 Do not over saturate carpet with cleaning solution while using Carpet Cleaner.
 For heavily soiled areas, additional applications may be necessary.
 Allow plenty of time for carpet to dry completely.
 Wipe cleaning solution from woodwork and wood to prevent damage.