Crofton VC9385S - Instructions for Use; Operating the Carpet Cleaner; Handling the Dirty Water Tank; Post-Use Cleaning and Storage

7
INSTRUCTIONS FOR USE
 Plug cord into electrical outlet. Turn on the Carpet Cleaner by using the on/off
switch located on the side of the machine.
IMPORTANT: Never leave unit unattended with power on. Turn off before emptying
and filling tanks. Do not over saturate the carpet.
 Step onto the handle release pedal to put the Carpet Cleaner into cleaning
position (Fig. 1).
 While depressing the solution release trigger (Fig. 2), pull Carpet Cleaner in a
backward motion. Release the trigger and push the unit forward in the same
path to agitate and remove dirty water and solution from the carpet.
NOTE: For heavier soiled areas repeat if necessary.
Fig. 1
Fig 2
IMPORTANT: For best results use a steady, moderate, forward and backward motion
(about 1 second per square foot.) Always work from back to front across the room to
avoid stepping on wet carpet and lowering pile.
 When dirty water tank is full, lift water tank latch (Fig. 3) and remove from base
using handle.
 Twist dirty water tank outlet cap to the left and remove, empty, rinse and replace
(Fig. 4).
Fig. 3
Fig. 4
 When finished cleaning, remove both dirty and clean water tank and rinse with
warm water and allow to dry before storage.
 Remove exhaust filter, rinse with warm water and allow it to dry thoroughly
before storing (Fig.5).
Fig. 5