10
THE FUNCTION OF CONTROL PANEL
CB-8500GW
Press this switch to turn the power “ON” or “OFF”.
Operation and temporary stop is repeated as it is pressed. When you want to change program in
operating; Press the “Start / Pause” button
→ Select the program that you want to change → Press the
“Start / Pause” button again.
You can select the course you want and each lamp is turned on when that course is selected.
It can be used to adjust water temperature according to types of the load to be washed.
As this button is pressed, water temperature is selected by Cold / Cold
→ Warm / Cold
→ Warm / Warm → Hot / Cold → Extra Hot / Cold
You can select the soil level you want and each lamp is turned on when that course is selected.
You can select the wash course you want and each lamp is turned on when that course is selected.
You can select the rinse time(s) you want and each lamp is turned on when that course is selected.
You can select the spin speed you want and each lamp is turned on when that course is selected.
It can be used to do only Rinse and Spin.
Use this function when you want to protect any accident occurring from handling of washer by a child.
During an operation, press ‘SPIN’ and ‘RINSE+SPIN’ buttons simultaneously during 3 second.
If this mode is set successfully, CHL and remain time will be showen on display alternately.
In Child Lock mode, no button functions except Power button.
And if you want to release this mode, press ‘SPIN’ and ‘RINSE+SPIN’ buttons simultaneously again
during 3 second.
If you want to change to the desire program, while this mode is working;
1. Press ‘SPIN’ and ‘RINSE+SPIN’ buttons simultaneously again during 3 second.
2. Press the ‘Start/Pause’ button.
3. Select the desired program and press the ‘Start/Pause’ buttom again.
*The Child Lock is cancelled after power is off.
It can be used to pre-engage time for wash from 2 hours to 12 hours..
If you want to open Door intensionally during operation, press the ‘Start/Pause’ button and press again
‘unlock’ button.
In this case, signal will be appeared on display, then you can open Door after cooling insideTub
temperature and draining water, also no button functions except Power button.
→→ →→ →→
Change
the desired
program
To Next Page
Loading...
Need help?
General
