23
GUIDE FOR OTHER USEFUL PROGRAMS
TIME DELAY (RESERVED WASHING)
1
2
3
4
5
Put the laundry into the Drum and put the detergent and softerner into the detergent
case.
Then close the Door.
• Put the detergent into the main wash room(I I marking) and prewash room(I marking)
in the detergent case.
• Softener should be below ‘MAX’ level.
• Put the detergent into the pre wash room(I marking) only if you want to add prewash.
• When you want to use bleach, put it into the main wash room (I I marking) with
detergent.
Press the Power button.
• The LED shows only ‘- --’ signal.
Select the program using the program selection dial.
• If you press ‘Start/Pause’ button aftrer pressing Power button without selecting
program, the ‘Cotton’ program is selected as default program.
• If you want to change the ‘Water Temperature’ and ‘Soil level’ and ‘Washing Course’
and ‘Rinse Time(s)’ and ‘Spin Speed’, select program what you want to change by
pressing each button.
Press the ‘Time Delay’ button.
• The ‘Time Delay’ LED is to be lighting.
• Select the time delay time you want from 2 hours to 12 hours by pressing button.
• The displayed time shows program finishing time.
Press the ‘Start/Pause’ button.
• If you make this program successfully, only ‘Time Delay’ and ‘Lock’ LED are lighting.
Note
• If you want to check the selected program, press the ‘Start/Pause’ button again.
• Preparing washing before starting ‘Time Delay’;
- Turn on the water tap.
- Load laundry and close Door.
- Place the detergent and fabric softner in the detergent case.
• The actual time of finishing may be slightly different from the displayed time because of water supply condition
or water temperature, etc.
• ‘WOOL’ and ‘DELICATE’ and ‘DRUM CLEANING’ programs can not be used with ‘Time Delay’.
• Adding clothes during ‘Time Delay’ operation is not allowed.
To Next Page
Loading...
Need help?
General
