General installation
,
,
Connect the exhaust duct to the outside exhaust system
(see pages 4 through 6). Use of a 4" (10.2 cm) clamp is
recommended to connect the dryer to the exhaust vent
system. Use metal foil tape to seal all other joints.
Carefully slide the dryer to its final position. Adjust one or
more of the legs until the dryer is resting solidly on all four
legs. Placea level on top of the dryer. The dryer MUST be
level and resting solidly on all four legs. Rock alternating
corners to check for stability. Remove and discard door
tape.
Be sure the power is off at a circuit breaker/
fuse box before plugging the power cord into an outlet.
3. Plug the power cord into a grounded outlet.
4. Turn on the power at the circuit breaker/fuse box.
5. Readthe Use & Care Guide provided with the dryer. It
contains valuable and helpful information that will save
you time and money.
6. If you have any questions during initial operation, please
review the "Avoid Service Checklist" in your Use & Care
Guide before calling for service.
7. Placethese instructions in a location near the dryer for
future reference.
A wiring diagram and technical data sheet are
located inside the dryer console,
wall rece
any circumstances,
Power coid with
3-prong grounded p!ug
13
To Next Page
Loading...
Need help?
General
