6
Initial Setup
Essential Setup
1. Slide the Turntable Lock to the right to release the turntable deck and place
the turntable on a flat and level surface. The selected location should be
stable and free from vibration.
2. Remove the tie-wrap that is holding the tonearm.
3. Connect AC adaptor to the Power Jack of the unit.
Note: Do not plug the AC power adaptor to power outlet before all the assembly is
completed. Before turning the power on, make sure again all the connection settings
are correct. Always turn off the power when connecting or disconnecting.
Aux Input Connection
You can connect an audio device to this unit and play your music through its
speakers. To do this, set the Function Switch to the Aux mode, and connect the
3.5mm auxiliary cable between your audio device and the Aux In Jack of this
unit and start playing.
Turntable Operation
1. Set the Function Switch to PHONO position.
2. Set the Speed Switch accordingly.
3. Place the record on the turntable. Use the 45 RPM Adapter if necessary.
4. Remove the stylus protector from the stylus assembly.
Note: To avoid stylus damage, make certain the included stylus guard is in place
whenever the turntable is being moved or cleaned.
5. Release the tonearm Hold Down Clip.
Note: when the turntable is not in use, remember to lock back hold down clip.
6. Lift up the Tonearm and move it over the record where play is desired to
begin. Gently put down the Tonearm and begin the playback.
7. When the record is finished playing, gently lift up the Tonearm and move it
back to the Tonearm Rest.
8. Lock the Hold Down Clip to secure the tonearm.
Tone Control
Slide the Tone Control can adjust the treble level of the turntable.
To Next Page
Loading...
Need help?
General
