EasyManua.ls Logo

Crosley CTWMS08B1 - User Manual

Crosley CTWMS08B1
26 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
USE & CARE GUIDE
0-14,000 BTU
Through The Wall A/C Unit
www.crosley.com
TM
Customer Focused. Quality Driven.
CTWMS08B1 | CTWMS10B1 | CTWMS12B1 | CTWMS12B2 | CTWME14B2
8,00

Questions and Answers

  • J
    Jeremy JonesAug 13, 2025
    What to do if my Crosley Air Conditioner is cooling, but the room is too warm with no ice forming?
    • J
      James PerezAug 13, 2025
      If your Crosley Air Conditioner is cooling, but the room remains too warm and there's no ice forming on the cooling coil, consider the following: * Ensure the air filter is clean. * Set the temperature to a lower setting. * Adjust the louvers for better air distribution. * Clear any blockages in front of the unit. * Close doors, windows, and registers. * Allow more time for the unit to remove stored heat from walls, ceiling, floor, and furniture.
  • J
    justinsullivanAug 16, 2025
    What to do if my Crosley CTWMS08B1 Air Conditioner is cooling, but the room is too warm and ice is forming?
    • C
      Cheryl MillsAug 17, 2025
      If your Crosley Air Conditioner is cooling, but the room is too warm and ice is forming on the cooling coil, it might be due to the outdoor temperature being below 64°F (18°C), a dirty air filter, or the thermostat being set too cold for nighttime cooling. To defrost the coil, set the unit to FAN ONLY mode. Clean the air filter if it's dirty. If the thermostat is set too cold, adjust the temperature to a higher setting.
  • J
    john60Aug 21, 2025
    How to fix a Crosley CTWMS08B1 Air Conditioner that does not start?
    • M
      Madison BarberAug 21, 2025
      If your Crosley Air Conditioner isn't starting, check these potential causes: * Make sure the wall plug is firmly pushed into the outlet. * Replace any blown house fuse with a time-delay type or reset the circuit breaker if it has tripped. * If the Plug Current Device has tripped, press the RESET button. * Ensure the power is turned ON.
  • A
    Amber McdowellAug 25, 2025
    Why is my Crosley Air Conditioner's air not cold enough?
    • E
      Edward BennettAug 25, 2025
      If the air from your Crosley Air Conditioner doesn't feel cold enough, it could be due to several reasons. If the room temperature is below 62°F (17°C), cooling may not occur until the room warms up. Also, ensure the temperature sensor behind the air filter isn't touching the cold coil. If these aren't the issue, try setting the unit to a lower temperature and wait for 3 minutes after setting it to the COOL mode.
  • M
    Margaret MartinezAug 28, 2025
    Why does my Crosley CTWMS08B1 turn on and off rapidly?
    • E
      Edward MorganAug 28, 2025
      Your Crosley Air Conditioner might be turning on and off rapidly due to a dirty air filter restricting airflow or because the outside temperature is extremely hot. Clean the air filter to resolve the restriction. If it's extremely hot outside, set the fan speed to a higher setting to increase airflow over the cooling coils.
  • S
    Shawn GreeneAug 31, 2025
    What to do if my Crosley Air Conditioner is making noise when cooling?
    • R
      Ryan EvansSep 1, 2025
      If your Crosley Air Conditioner is making noise while cooling, it could be due to air movement. If the sound is too loud, try setting the fan to a slower speed. Alternatively, window vibration from poor installation could be the cause. In this case, refer to the installation instructions or consult with the installer.
  • S
    Stacey RodriguezSep 5, 2025
    What to do if my Crosley CTWMS08B1 is dripping water inside when cooling?
    • R
      Rodney SteeleSep 5, 2025
      If your Crosley Air Conditioner is dripping water inside while cooling, it's likely due to improper installation. To resolve this, tilt the air conditioner slightly to the outside to allow for water drainage. Refer to the installation instructions or consult with the installer for guidance.
  • G
    garciamarkSep 8, 2025
    Why does my Crosley Air Conditioner remote sensing deactivate prematurely?
    • E
      ebrownSep 8, 2025
      If the remote sensing on your Crosley Air Conditioner is deactivating prematurely, ensure the remote control is within a 20-foot range and 180-degree radius of the front of the unit. Also, check for and remove any obstructions that may be blocking the remote control signal.

Crosley CTWMS08B1 Specifications

General IconGeneral
Voltage115V
Noise Level52 dB
Fan Speeds3
Installation TypeWindow
Filter TypeWashable
Remote ControlYes
Timer24-hour
ColorWhite
Cooling Capacity8000 BTU
Room SizeUp to 350 sq ft
ThermostatYes
TypeWindow

Related product manuals