IMPORTANT - Advice and safety - Please read before installation
MPRO BATHROOM VANITY
January 2019
Please read these instructions carefully before starting
installation and keep in a safe place for future reference.
Important! Risk of product damage. Do not modify the vanity.
Doing so will compromise structural stability and warranty.
This instruction manual contains information on how install the
MPRO collection.
Note. This series comes in several sizes and one semi-column;
the installation procedures remain the same. Observe all local
building codes.
Two people should install this product.
This vanity series needs specic site preparation. Do not install
vanities until all support framing and plumbing rough-ins have
been completed and wall surface has been nished.
Secure the vanity to stud framing. When possible, provide 2X6
timber behind the nished wall for additional support. To ease
installation, remove drawers from the vanity before tting. Refer
to the section in this guide for proper removal.
Advice & Safety
This product should only be installed by a suitably qualied
plumber/installer. Should the installation be completed by a non-
qualied person any product guarantee maybe considered invalid.
Ensure the room is well heated and ventilated.
Warning! Please check for any hidden pipes or electrical cables
before drilling holes in the floor or walls.
Do not over tighten tap or waste ttings, doing so may result in
damaging the basin.
The vanity units CAN ONLY BE installed using the tting
brackets supplied. Before installing a wooden bathroom product
into a new property extension or recently plastered room we
strongly advise the building/room is completely dry, well ventilated
and adequately heated prior to installation.
Save these instructions for future use and reference. An improper
installation voids the warranty. Installed vanities cannot be returned.
If you experience any problems with your vanities, contact your
dealer or Crosswater directly.
24’’Two-Drawer Vanity
and basin
28’’ Two-Drawer Vanity
and basin
x2
39’’ Two-Drawer Vanity
and basin
x2
48’’ Two-Drawer Vanity
and basin
x2
Basin US-PRO24
33-
1
/
2
lbs
Basin US-PRO28
36-
1
/
2
lbs
Basin US-PRO39
55-
1
/
2
lbs
Basin US-PRO48
58 lbs
Vanity US-PRO24D
55-
1
/
2
lbs
x2
x8
x8
Vanity US-PRO28D
64 lbs
Vanity US-PRO39D
81-
3
/
4
lbs
Vanity US-PRO48D
121-
1
/
2
lbs
x8 x8
Tools & equipment needed:
To Next Page
Need help?
General
