Crowcon Clip User Manual

Crowcon Clip and Crowcon Clip+
Fixed Life Single Gas Monitor
Installation and Operation Manual
Issue 4
December 2016
Crowcon Clip and Crowcon Clip+
Fixed Life Single Gas Monitor
Installation and Operation Manual
Issue 4
December 2016
Crowcon Clip and Crowcon Clip+
Fixed Life Single Gas Monitor
Installation and Operation Manual
Issue 4
December 2016

Crowcon Clip Specifications

General

Target Gas	Oxygen (O2), Carbon Monoxide (CO), Hydrogen Sulfide (H2S), Combustible gases (LEL)
Gas detected	O2, CO, H2S, LEL
Measurement Range (O2)	0-25% vol
Measurement Range (H2S)	0-100 ppm
Measurement Range (LEL)	0-100% LEL
Operating Temperature	-20°C to +50°C
Display	LCD
Device Type	Portable
Sensor Type	Electrochemical (O2, CO, H2S), Catalytic (LEL)
Ingress Protection	IP66/67
Protection Rating	IP66/67
Alarms	Audible, visual, and vibration alarms
Certifications	ATEX, IECEx, UL
Battery Life	2 years (typical)

Summary

Safety and Initial Operation

General Warnings and Precautions

Essential warnings regarding activation, modifications, daily checks, and battery disposal.

Calibration and Bump Test Recommendations

Guidelines for O2 calibration and recommended bump test intervals and procedures.

Device Activation and Usage

Activation Process

Steps to activate the Crowcon Clip/Clip+ monitor and initial display indications.

Day-to-Day Usage and Self-Test

Operational Features and Troubleshooting

Failure Handling and FAQs

Actions to take if self-tests fail or if the battery is low, including Fail Safe mode.

Alarms and Environmental Monitoring

Alarm Types and Indicators

Details on low, high, over limit, and life countdown alarms (audible, visual, vibrating).

IR Link Software Operations

Software Installation and Setup

Changing Device Settings

Customizing alarm set points, bump intervals, user IDs, and self-test frequency.

IR Link Software Configuration