EasyManuals Logo

Crowcon Tetra User Manual

Crowcon Tetra
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
Run mode
Your unit is now ready to use.
Below is a typical screen display showing the
unit in normal gas monitoring Run mode.
Familiarize yourself with the gases being
monitored in your unit and make sure you
understand site health and safety procedures
in the event of alarm conditions.
Tetra units with an inbuilt pump will produce
a low humming noise, this is normal.
2. In the event of an alarm
Alarm signals
In the event of gas concentrations exceeding the alarm thresholds for any gas
being monitored, Tetra will activate the alarm signals.
Alarm signals
The red and blue
alarm LEDs will flash,
the sounder will emit
a loud, fast series of
beeps, the internal
vibrator alarm will
activate. The
operator screen will
display the gas in
alarm and the alarm
level. See the figure
to the left.
4
In the event of an alarm Tetra
CH4 %LEL CO ppm
H2S ppm
O2 %
0.0
0.0
0
20.8
OK
OK
Flashing
icon, Tetra
running
normally
Pump
Battery
Screen Icons
Auto zero
Warm up
Confidence signals
In normal Run mode, Tetra will emit a short beep every 10 seconds and the
OK icon flashes to show operational health.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Crowcon Tetra and is the answer not in the manual?

Crowcon Tetra Specifications

General IconGeneral
Operating Temperature-20°C to +50°C
TypePortable Gas Detector
Gases DetectedOxygen, Carbon Monoxide, Hydrogen Sulfide
DisplayLCD
Ingress ProtectionIP65
Sensor TypesElectrochemical

Related product manuals