To Next PageTo Next Page
Need help?Do you have a question about the Crown Boiler AWR070 and is the answer not in the manual?
Details minimum clearances required around the boiler to prevent fire hazards and ensure access.
Explains how to supply combustion air from within the building using natural infiltration.
Lists approved chimney types and installation requirements for venting the boiler.
Specifies approved materials and types for vent connectors used with the boiler.
Guidance on selecting the correct size for chimneys and vent connectors based on codes.
Explains the typical components and connections for a single-zone hydronic system.
Details on how to connect the main 120VAC power supply to the boiler.
Overview of the boiler's control system and its capabilities.
How to navigate the boiler's control interface to view status and parameters.
General advice and precautions to consider before starting the troubleshooting process.
Steps to diagnose issues when the boiler's control display is not showing any information.
Instructions for interpreting and resolving error codes displayed by the boiler control.
Troubleshooting steps for situations where no error code is shown, but a problem exists.
General| Model | AWR070 |
|---|---|
| Fuel Type | Natural Gas or Propane |
| Heating Capacity | 70, 000 BTU/h |
| Water Content | 4.9 gallons |
| Vent Size | 3 inches |
| Weight | 160 lbs |
| Input BTU/h | 70, 000 |
| Type | Water Boiler |
| Input BTU | 70, 000 BTU/hr |
| Output BTU/h | 63, 000 BTU/h |
| Output BTU | 63, 000 BTU/h |
