Need help?Do you have a question about the Cruisair TWLC and is the answer not in the manual?
Displays sensor values, board output status, and software version.
Allows adjustment of temperature set points, limits, and other system parameters.
Analyze 'Loop Water Out' vs 'Com Loop Return' difference for flow issues.
Verify pump inlet pressure is within the specified range (12-18 PSI).
Inspect the common loop strainer for blockages.
Inspect individual strainers in MTC or earlier models for debris.
Unplug and measure sensor resistance against a calibration chart.
Clean plugs with contact cleaner or repair/replace corroded harnesses.
Ensure sensors are correctly located, connected, and have good contact.
General| Brand | Cruisair |
|---|---|
| Model | TWLC |
| Category | Controller |
| Language | English |
To Next Page
