Download the full PDF manual at www.crumar.it/support
SYSTEM USB PORTS
USB-host ports - use them to connect
USB class compliant MIDI controllers,
USB flash drives, WIFI module.
Max current draw: 300mA.
WIFI PASSWORD RESET
Just press the button
inside the hole in case
password is lost.
HEADPHONES OUT
CONNECTOR
OUT LEVEL SELECTION
«L» - consumer level 10dB.
«M» - professional level +4dB.
«H» - ONLY FOR OLD AMP SYSTEM.
Improper use of this setting can reduce S/N ratio.
BALANCED OUTPUTS
Audio left and right TRS
balanced outputs.
Connect your amplification
system here;
please set «OUT LEVEL»
accordingly.
AC MAIN PLUG INLET
From 100 to 240 VAC.
Suitable for every Country.
POWER ON/OFF
BUTTON
Fun starts here.
SUSTAIN PEDAL INPUT
Used for sustaining
notes. In VB3 mode can be
set for rotary speeds too.
EXPRESSION PEDAL INPUT
TRS Jack input - signal on ring
from 10k to 20k linear pot.
MIDI IN PORTS
2 Standard MIDI IN
cables plugs.
MIDI OUT PORT
Standard MIDI IN
cables plug.
MIDI IN/OUT USB
Device type B USB port used to connect
Crumar Mojo61 to your computer for MIDI
input and output connectivity.
HALFMOON OR FOOT SWITCH
Here you can connect our dual
rail foot switch or our halfmoon.
Please note: be sure to use a foot
switch specifically made for Mojo61.
Please note: halfmoon can only be attached
to the optional Lower Manual for Mojo61.
Getting Started
1. Connect AC cord.
2. Connect audio outs to your mixer/amp.
3. Connect all accessories you wish to use.
4. Push ON/OFF button.
5. Leds on the panel will lit.
6. Be sure to open the drawbars.
7. After 8 seconds, the instrument is ready to be
played.
To Previous Page
Loading...
