5. GLOBAL SETTINGS
The list includes the following items:
– Tuning A=Hz; This is the global
tuning, where the reference A note
can be set to a frequency between
430 and 450 Hz. The default value is
440 Hz.
– MIDI Channel selection for Upper,
Lower and Pedalboard. The default
values are, respectively, 1, 2 and 3.
These can be set on any channel between 1 and 16. Settings two ore more
manuals on the same channel will cause them to play simultaneously when
that channel is received.
– Receive MIDI Program: set this to ON (default) if you wish to switch programs
from the external MIDI Program Change event. Set to OFF to ignore the event.
– Receive MIDI Control: set this to ON (default) for controlling certain
parameters from external MIDI Continuous Controller messages. Set to OFF to
ignore the events.
– Send MIDI Program: set to ON to send MIDI Program Change events when a
new Program is recalled. Set to OFF to ignore (default).
– Send MIDI Control: set to ON to send MIDI Continuous Controller messages.
Set to OFF to ignore (default).
– Volume is Global: set to ON (default) to use the Volume knob as a global
volume. Set to OFF if you wish the volume parameter to be set according to the
Programs.
– MIDI CC #64 Function: decide what to do when a MIDI CC #64 event (Sustain
Pedal) is received:
– OFF (default): ignore the messages;
– Rotary Speed (Latch): use the sustain pedal to switch between rotary speeds in latched
mode, i.e. the speed changes each time the pedal is pushed and released;
– Rotary Speed (Mom.): use the sustain pedal to switch between rotary speeds in
momentary mode, i.e. hold the pedal down for slow, release for fast;
– Sustain Upper, Lower, All: decide whether to use the sustain pedal to sustain notes on
the upper manual only, or on the lower manual only, or on both manuals.
CRUMAR MOJO DESKTOP USER'S MANUAL - Page 11/20
To Next Page
Loading...
