USING THE ILLUMINATED RGB ENCODERS
The encoders can be used to perform three different operations:
1. turn effects on or off;
2. switch between two different parameters;
3. set the parameter values.
All knobs are both input and output devices. The colors indicate the approximate
value of a parameter, they can fade between green ~ red or blue ~ red.
Each knob can be pushed in two ways to make two distinct operations:
SLOW PUSH, keep pushed for at least 100 milliseconds then release;
QUICK PUSH, push and release immediately.
SLOW PUSH to turn effects on or off; QUICK PUSH to switch between parameters. If
the first knob is blue, the instrument won't produce any sound because it's set on
LOCAL-OFF. Slow push on the first knob to turn LOCAL ON.
The following table shows the functions of the eight knobs and the colors they use.
KNOB PARAMETER 1 COLORS PARAMETER 2 COLORS SLOW PUSH QUICK PUSH
1 VOLUME GREEN-RED - BLUE LOCAL ON-OFF -
2 REVERB LEVEL GREEN-RED REVERB DECAY BLUE-RED REVERB ON-OFF Switch parameter
3 EQ TREBLE GREEN-RED EQ MID GREEN-RED EQ ON-OFF -
4 EQ BASS GREEN-RED EQ MID FREQ. GREEN-RED EQ RESET Switch parameter
5 FX1 DEPTH GREEN-RED FX1 RATE PULSING BLUE FX1 ON-OFF Switch parameter
6 DRIVE AMOUNT GREEN-RED - AMP/DRIVE ON-OFF -
7 FX2 DEPTH GREEN-RED FX2 RATE PULSING BLUE FX2 ON-OFF Switch parameter
8 PAD LEVEL GREEN-RED PAD BLEND BLUE-RED PAD ON-OFF Switch parameter
USING THE PRESETS
There are 4 banks of 8 presets each, that can be recalled or stored using the 8
numbered buttons. The first bank, with a red LED, is read-only and can't be
overwritten by the user.
– To recall a preset, select the bank by pushing the BANK button, the LED
starts blinking, then push the desired preset number.
– To save a preset, first select a user bank (those with yellow LEDs) then push
and hold the desired preset button for at least 3 seconds, until you see an
LED animation.
To Previous Page
Loading...
