Need help?Do you have a question about the Crunch PZi 100.2 and is the answer not in the manual?
Introduction to the high-end car audio amplifiers, their design philosophy, and key features like variable crossovers and diagnostic modes.
Guidelines for optimal system design, amplifier placement, and mounting to ensure proper heat dissipation and prevent noise.
Instructions for safely and correctly connecting power and ground cables, including wire gauge recommendations and secure connection methods.
Detailed description of controls and features for 2-channel and 4-channel PowerZone amplifiers, including crossover and mode settings.
Description of features and controls for 1-channel mono block and D-Class mono amplifiers, covering bass boost, subsonic, and low-pass filters.
Setup guide for basic full-range stereo operation using 2-channel amplifiers with LINE INPUTS and speaker outputs.
Setup guide for mono bridged operation using 2-channel amplifiers, requiring a mono signal source and Y-adapter.
Guide for setting up a 2-way active system using two 2-channel amplifiers for highs and lows, including crossover and wiring details.
Instructions for using 4-channel amplifiers as standard discrete 4-channel full-range units for a complete speaker setup.
Guide on utilizing 4-channel amplifiers for 2 or 3-channel systems by mono bridging specific channel pairs.
Setup for a 2-way active system using a 4-channel amp for highs and mono bass, detailing crossover and wiring configurations.
A variation of the bi-amplified system using front/rear outputs from a head unit for fade control of highs and bass.
Guide for basic application of 1-channel mono block amplifiers, suitable for sub bass systems or replacing 2-channel amps.
Guide for basic application of D-Class mono amplifiers, usable in bi-amplification or as replacements for 2-channel amps.
Instructions for using the 5-channel amplifier as a discrete 5-channel full-range unit for a complete system setup.
Detailed guide for setting up high pass, low pass, bass EQ, and level controls for 2, 4, and 5-channel amplifiers.
Detailed guide for setting up subsonic, low pass, bass EQ, phase, and level controls for mono amplifiers.
Diagnosing issues related to the amplifier's PROTECT LED, speaker short circuits, internal faults, and heatsink overheating.
Troubleshooting low output power, blown fuses, no power, hiss, electrical interference, and engine-related noise issues.
General| Channels | 2 |
|---|---|
| RMS Power @ 4 Ohms | 50W x 2 |
| Total Harmonic Distortion (THD) at RMS Output | <0.05% |
| Signal to Noise Ratio | >95dB |
| Bass Boost | 0-12 dB |
| Input Sensitivity | 200mV-6V |
| Fuse Rating | 25A |
| Crossover | Variable Low-Pass |
To Next Page