4:1
For spares and service, contact your local supplier or installer stating the appliance NAME, MODEL, SERIAL
NUMBER
4:2
Regular service and inspection should be undertaken to ensure continued safe operation.
It is recommended that your fire and flue should be checked and serviced annually by a competent person for
continued safe operation
7 issue 5
3.cleaning and simple maintenance
4.spares and service
5.user replaceable parts
3:1
All cleaning should be carried out when the fire is cold. The fire will retain heat for some time after it has been
switched off.
3:2
If any of the Fuel Effect Logs Driftwood or Pebble Pieces is seen to be broken or damaged replacements must be
obtained from your Installer.
If soot is seen to be building up on the Fuel Effect Logs Driftwood or Pebble Pieces it is indicating that the Fire
requires Servicing.
3.5
Due to the nature of the convection air flowing over the fire the walls of the room directly around and above the fire
may become discoloured. This is due to particles of dust being carried by the convection air through the fire and up
and around the walls.
Certain wall coverings like blown vinyl should not be used on the wall around the fire.
3.6
Again ensure the fire and glass panel are cold before proceeding.
Like all glass windows the glass will become dirty and require cleaning.
The glass door can be cleaned on both the outside and inside with a damp cloth, allowed to dry then wiped with a
dry cloth to remove smears. To do this open the Outer Door
remove the 2 screws at the Left Hand side, the Glass Door will then open.
Important.
After cleaning it is important that the Glass Door is sealed closed with the 2 fixing screws.
If the Glass Door Panel is found to be Cracked, Chipped or Damaged the Fire Must Not Be used until it has
been changed.
Important.
Do not disturb the Fuel Effect Logs Driftwood or Pebble Pieces.
To Next Page
